Shop ETS Apps

DCA for commissioning the MDT DaliControl Gateway DALI16 or the MDT DaliControlGateway32.
This DCA can be used to commission and configure the DALI devices. The DALI subscribers can be assigned to the various groups and scenes and time controls can be implemented.
For more information: http://www.mdt.de

Device Configuration App (DCA) for IPAS DALIControl gc16 (1 or 2 Channel)
Order No.: 4101-145-11, 4101-145-21
Application: DaliControl gc16-01-0110, DaliControl gc16-2-01-0110

Coloured light control including device type 8 ECGs:
Colour temperature (DT-8 Sub-Type TC)
XY colour (DT-8 Sub-Type XY)
RGB (DT-8 Sub-Type RGBWAF)
HSV (DT-8 Sub-Type RGBWAF)
RGBW (DT-8 Sub-Type RGBWAF)
HSVW (DT-8 Sub-Type RGBWAF)

Device Configuration App (DCA) for IPAS DALIControl gc16plus (1 or 2 Channel)
Order No.: 4101-145-11, 4101-145-21
Application: DaliControl gc16-1 Plus_V1.1.0, DaliControl gc16-2 Plus_V1.1.0

Coloured light control including device type 8 ECGs:
Colour temperature (DT-8 Sub-Type TC)
XY colour (DT-8 Sub-Type XY)
RGB (DT-8 Sub-Type RGBWAF)
HSV (DT-8 Sub-Type RGBWAF)
RGBW (DT-8 Sub-Type RGBWAF)
HSVW (DT-8 Sub-Type RGBWAF)

DLC-02-KN is a KNX to DALI gateway, used to connect DALI ECGs/ Driver via KNX installation.
This device Configuration App (DCA) is designed for the special surface for the DALI configurations.

The KNX IQ08 TPS device from DIVUS GmbH can be easily configured using the DIVUS KNX IQ DCA.
With the DIVUS VISION software, device parameterization is simple and intuitive. The configuration file exported from DIVUS VISION can be imported into ETS via the DIVUS KNX IQ DCA, where group addresses are assigned. Device download is performed through the known procedure in ETS.
Existing configurations can also be exported from the DIVUS KNX IQ DCA and so be modified in DIVUS VISION.

domovea secured proxy app helps you to establish a secured proxy KNX/IP tunnelling in order to connect safely to a remote KNX installation in ETS.

Reactivates the protocol EIBlib/IP in ETS (not standardised and since KNXnet/IP redeemed). With this ETS App the establishment of an ETS connection using with this protocol is again possible.

Area of application:
With the ETS Service App, KNX Secure devices from Elsner Elektronik can be conveniently maintained. Use the programming interface of the ETS to:
- Import new firmware versions
- Transfer older firmware versions, e.g. when replacing a device.
The ETS Service App supports all KNX media (TP, IP, RF).

DCA for configuring ERA INN KNX interface DIN module.