Scope:
Feller's ETS service app provides users with a convenient way to maintain devices. New firmware can be installed onto existing devices. Furthermore, it is also possible to transfer older firmware versions to existing devices (for example, when replacing your device).
The ETS programming interface is used during the firmware programming process. The app supports all KNX media (TP, IP, RF).
https://www.feller.ch
This DCA Version A enables the KNX panel 7" Version A from Feller to be commissioned. Via the ConfigTool Version A the KNX-Panel 7" can be parameterized easily and intuitively. Afterwards the configuration file is imported into the ETS via the DCA, where the group addresses are linked. The download is then carried out via the ETS standard mechanism. Furthermore, an existing parameterization can be exported in the DCA and thus be edited in the ConfigTool.
This DCA enables the KNX-Panel 7" Version B from Feller to be commissioned. Via the ConfigTool Version B the KNX-Panel 7" version B can be parameterized easily and intuitively. Afterwards the configuration file is imported into the ETS via the DCA, where the group addresses are linked. The download is then carried out via the ETS standard mechanism. Furthermore, an existing parameterization can be exported in the DCA and thus be edited in the ConfigTool.
This Device Configuration App (DCA), which is fully integrated into the ETS and supplements the standard parameter dialog, is used to carry out DALI commissioning and the DALI test for the DALI Gateway Color. This makes it possible to identify, address and assign DALI operating devices using the familiar ETS environment without having to use additional software outside the ETS.
https://www.Feller.ch