This app is used to configure the AC / S 1.x.1 Application Controllers. The graphical user interface of this app allows an intuitive parameterization of the application-specific automation modules (ASM).Basic device settings and device programming (download) are also possible without this app.

The KNX DALI-Gateway REG-K/IP1 is a device used to control ECGs with a DALI interface via the KNX installation bus.

The special surface for the configuration of DALI segments is designed as a DCA (Device Control App) for the ETS5.

With the “KNXMCM BAline Studio Exchange” ETS app, CSV files that were previously generated in BAline Studio can be imported to ETS. These files contain information about names and types of objects and the direction of data flow, which were set in BAline Studio projects.

With “KNXMCM BAline Studio Exchange” the settings on KNX devices can be easily made so that the corresponding BAline Studio Project can run perfectly on these devices.

“KNXMCM BAline Studio Exchange” can in each case be run for only one device.

If a receiver heartbeat was set up for group objects in BAline Studio, a message appears in the “Information” field.

This DCA enables the KNX panel 7" from Feller to be commissioned. Via the ConfigTool the KNX-Panel 7" can be parameterized easily and intuitively. Afterwards the configuration file is imported into the ETS via the DCA, where the group addresses are linked. The download is then carried out via the ETS standard mechanism. Furthermore, an existing parameterization can be exported in the DCA and thus be edited in the ConfigTool.

This app synchronizes the KNX-Gate 3 projects of the Insta KNX Gateway RS232/485-IP with an ETS Project.